Scrolling down displays DHCP, DNS and gateway information. Ping result screen shows response time to target for each of four pings. Results of the ping test include identification and response time of each of four pings to the target, the DNS server and gateway. Once set up, the ping test is run as part of the Autotest when a switch is detected. The LinkIQ’s address may be set up manually or through DHCP. The ping test verifies connectivity to devices on the local network or the internet and supports both IPv4 and v6. Scrolling down shows Power over Ethernet results If a ping test is configured, the target address and maximum response time are shown. Switch port test shows switch name and IP address, connected port, and VLAN along with advertised speed and duplex settings. The LinkIQ negotiates with the switch to identify the advertised data rate (up to 10GBASE-T), half/full duplex identification, the switch name and IP address, port number, and VLAN info. Īlong with the robust cable testing features, the LinkIQ also provides detailed information on the nearest connected switch and connectivity testing with IP ping. Ĭable test with remote attached shows remote ID number 1, length and pairing of each wire and cable performance of up to 2.5 Gb/s but failed the test due to a user-set limit of 10 Gb/s performance. Operators may set performance requirements from 10 Mb/s to 10 Gb/s for a simple pass/fail indication.Ĭable test without remote attached shows length and pairing of each wire.Ĭable test with remote attached shows remote ID number 5, length and pairing of each wire and cable performance of up to 10 Gbps. Using IEEE-standards-based measurements ensures that tested links meet performance requirements as opposed to transmission testers which only prove that the specific test devices can communicate over the link. It performs these tests via frequency-based measurements. The primary cable testing feature of LinkIQ is the cable performance test which qualifies the cabling bandwidth from 10BASE-T to 10GBASE-T (10 Mb/s up to 10 Gb/s). Using the remote ID allows for a complete wire map of the cable pairs which helps identify miswired and split pairs. The LinkIQ is capable of measuring lengths up to 1000 feet (305 m) and provides distance to faults such as opens, shorts, and unterminated cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |